Data Fall Slew Rate Definition

DspSee Symbol

Active Edge	Data Fall Slew Rate
Not Applicable	It is defined as	Data high threshold - Data low threshold Data fall time

Significance of statistics:
Mean	Not important.
Min	The min fall slew rate should be more than the specified limit. Too large a fall slew rate will eat into the setup & hold times.
Max	The max fall slew rate should be less than the specified limit. Too small a fall slew rate will induce noise on adjacent signal lines.
Peak cy-cy	Important. A higher cycle-to-cycle fall slew rate indicates that the system is affected by noise or interference from adjacent signals or both.
Peak-to-peak	Not important.